READY

Ready-Made-Solutions

LOGO! 8+

We now offer Siemens new Logo!8 Logic Module complete with pre-loaded standard application(s). Contact us for more information now!

Logo!8+ Sequence Start/Stop
Description :
Take control of the delay time to turn ON & OFF field equipment when an Emergency stop switch is deactivated or activated.
Logo!8+ Hourly Alarm Timer
Description :
This application is to control one output (alarm). The alarm will be activated on a daily basis, for one minute every hour between 8am & 7pm. Time setting can be changed via Webserver.
Logo!8+ Datalog
Description :
Convert your field instrument device’s output value into trend curve by extracting the logged data & plotting the graph using available PC software to save on your expenditure.
Logo!8+ 2 Duty 1 Standby
Description :
This application is to control three pumps (alternate run). A maximum of two pumps will run at a time (based on the level). Delay time to start and stop the pump (can be changed via Webserver).
Logo!8+ 2 Duty 2 Standby
Description :
This application is to control four pumps (alternate run). A maximum of two pumps will run at a time (based on the level). Delay time to start and stop the pump (can be changed via Webserver).
Logo!8+ DCS
Description :
- LOGO! 8 DCS is the scalable lite version of packaged HMI for minor Digital Capturing System requirement in Building Management Services, Facilities Maintenances and Services, Pilot Plant, IOT based Home Automation etc.
- LOGO! 8 DCS is available in type 32 points or 44 points, both with built-in 4 nos of analogue point ( 0~10VDC, resolutions 1000 )


IOT2000 +

Accessing plant data & status is just a tab away !




No comments:

Post a Comment

Note: Only a member of this blog may post a comment.